  
Plus Deck 2 - Transfer cassettes to MP3 and Wave files
5.25" bay 1EA
Slot 1EA
Soundcard (analog Line Out, Line In essential)
20MB of hard drive space for program installation
Windows 98 or higher
The Plusdeck2 comes with the following components:
Plusdeck2 internal drive
20 pin cable
Connection card
Serial cable (RS232C cable)
Stereo Cable 3 EA
Plusdeck Manager CD
User manual (74pages)
Fixing screws
Size (W*H*D): 145*40*215mm
Tape speed: 4.75Cm/sec
Wow & Flutter: 0.09%(WRMS)
Frequency response: 20 ~ 18,000Hz
Separation: 40dB
Signal to Noise Ratio : 55dB
Power: DC12V
Patent issue 0390012
International patent PCT/KR01/1567
Registration of design 30-2001-0034551
Registration of program 2001-01-23-4046
Best prize of the second Digital Innovation
Success Design of KIDP(Korea Institute of Design Promotion)
Procurement Success Designed Special Product chosen by Supply Administration
Best New Product chosen by The Handbook Ilbo
Hit Product chosen by Electronic Newspaper
Hit Product chosen by Computer Times
Emerging Success Technique Award chosen by The Seoul Economy, etc
FCC Information This device complies with Part 15 of the FCC Results. Operation is subject to the following two conditions: (1) This Device may not cause harmful interface, and (2) This Device must accept any interference received, including interference that may cause undesired operation.
Note: This is equipment has been tested and found to comply with the limits for CLASS B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to the radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try correct the interference by one or more of the following measures :
1.1. Reorient or relocate the receiving antenna. 1.2. Increase the separation between the equipment and receiver. 1.3. Connect the equipment into an outlet on a circuit different from that to which receiver is connected. 1.4. Consult the dealer or experienced computer technician for help.
WARNING Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment.
1. Make sure the computer is off during installation.
2. Pay attention to the sharp metal edges inside the computer casing, this might hurt you.
3. Do not insert things or touch other parts inside of computer during setting up.
4. Do not make the setup at unstable position, or in a direct exposure to sun shine or intense light, be sure to have a dry place and hands.
5. Be sure to have a dry place and hands.
6. Avoid dropping or other physical impact.
7. Keep small parts like screws out of a reach of children.
8. Do not insert or attempt to use damaged tapes.
9. Do not move or shock Plusdeck when running.
10. Be careful not to delete or damage important files.
11. Be careful not to insert you finger or different things into Plusdeck.
12. Do not disassemble, explore, or attempt to fix without permission at an appointed service centers
13. Read user manual thoroughly.
|
